I switched from MIG to flux core welding on a thick steel trailer frame—it was a game-changer but also a bit intimidating. Many welders, especially beginners, wonder what flux core welding is used for and when it’s better than MIG…
I’ve lost count of how many times I’ve walked into the shop, ready to start a weld, only to find a piece of mild steel covered in rust. It’s a common frustration, whether you’re running MIG vs TIG, setting up…
When I first got my hands on a Lincoln welder, I thought dialing in the right settings would be straightforward—but I quickly realized that voltage, amperage, wire feed speed, and metal thickness don’t always play nice together.…
I tried welding on a flimsy workbench that wobbled every time I struck an arc — and believe me, nothing kills your weld quality faster than chasing stability while trying to control your puddle. That’s when I realized a solid,…
When I first started running beads with stick, one of the biggest headaches I had was figuring out the right amperage setting for different rods and metal thicknesses. Too low, and the arc would stick and sputter; too high, and…
If you’ve ever pulled off your hood to find tiny holes pockmarking your weld bead, you’ve likely encountered porosity in arc welding. It’s one of those frustrating defects that can turn a solid weld into a weak, unreliable joint. As…
I can’t count how many times I’ve been in the middle of a MIG weld, thinking everything was set up right, only to run into spatter everywhere, poor penetration, or that dreaded bird-nesting at the wire feed. One of my…
I can’t tell you how many times I’ve seen new welders struggle with flames that are either too weak to penetrate thicker metal or too aggressive, leaving the joint brittle and full of porosity. Back when I first started learning…
Back when I first struck an arc in a cramped garage corner, I thought my biggest challenge would be dialing in the right settings for different rods and metal thickness. But I learned the hard way that even perfect arc…
I can’t count how many times a weld went south on me simply because I rushed the prep and skipped properly cleaning the mild steel. Back when I first started burning rods, I thought a quick wire brush was “good…